Инструкция по эксплуатации ваф парма ваф а

Page 5: Table Of Contents

РА1.007.001РЭ-001 PARMA Ltd. РА1.007.001РЭ-001 PARMA Ltd. 7.6.7.9 Turn the clamp so that to place the marking plate in upper CONTENTS position and repeat the measurements. 7.6.7.10 Turn off all clamps. Normative References …………..6 7.6.7.11 Make parallel connection of the outer voltage of the system Definitions, Designations and Abbreviations ……..

Page 6: Normative References

Set the output voltage of UPPU-1M system on 100 V, out- The present Service Instructions contain the following terms: put current on 5 A, current-voltage phase shift equal to zero. Control phase Device — Voltamperephasometer “Parma ВАФ-A”. shift by phase shift meter F2-34. GOST — Russian State Standards.

Page 7: Safety Requirements

OF ITS OPERATION sure that the surfaces are clean. Purpose 7.6.2 Determination of insulation resistance 4.1.1 Voltamperephasometer “Parma ВАФ-A”, TU4221-006- 7.6.2.1 Insulation resistance measurement is made with megger at 31920409-2004 is a completely automatic universal device. a fixed voltage of 1000 V.

Page 8: Operation Conditions

РА1.007.001РЭ-001 PARMA Ltd. РА1.007.001РЭ-001 PARMA Ltd. Operation is made Operation conditions during 4.2.1 Normal conditions of use of the device according to GOST Names of operations Point Initial Periodical 22261. number Verifi- Verifi- 4.2.2 Nominal temperature of ambient air is 20°C. Admissible de-…

Page 9: Electric Strength And Insulation Resistance

РА1.007.001РЭ-001 PARMA Ltd. РА1.007.001РЭ-001 PARMA Ltd. Electric strength and insulation resistance DEVICE VERIFICATION (CHECK OF CALIBRATION) 4.4.1 Electric strength and insulation resistance conforms to GOST Standardized Methrological Characteristics 26104 requirements. 4.4.2 Insulation resistance between short-circuits or equivalent cir- 7.1.1 Effective Range: cuits, insulated from the case of the device, on the one hand, and the other cir- −…

Page 10: Design And Operation Of The Device

РА1.007.001РЭ-001 PARMA Ltd. РА1.007.001РЭ-001 PARMA Ltd. Opening of magnetic circuit of clamps 9±0.5 90° Mass, no more than, kg Dimensions, no more than, mm 190x70x160 DIRECT 180° 0° 120° Design and operation of the device PHASE SUCCESSION –120° 4.7.1 Design 4.7.1.1…

Page 13: Preparation For Usage

РА1.007.001РЭ-001 PARMA Ltd. РА1.007.001РЭ-001 PARMA Ltd. 4.7.2.2 The device consists of two galvanically separated parts: reference and measurement channels. 90° 4.7.2.3 The reference channel is intended for formation of signals necessary for measurement of phase shifts of galvanically isolated circuits.

Page 14: Operation Order

РА1.007.001РЭ-001 PARMA Ltd. РА1.007.001РЭ-001 PARMA Ltd. Don’t store the device with deeply discharged batteries. This 6.2.2 Measurement of effective value of alternating voltage and may cause electrolyte leakage and damage of the device. its frequency OPERATION ORDER 6.2.2.1 To measure the effective value of alternating voltage and its frequency apply alternating voltage to terminals, named Um (see fig.

РА1.007.001РЭ-007
ВОЛЬТАМПЕРФАЗОМЕТР
®
«ПАРМА ВАФ -А»
Руководство по эксплуатации
РА1.007.001 РЭ
ООО «ПАРМА», Санкт-Петербург

ООО «ПАРМА»                                  РА1.007.001РЭ-007
Внешний вид вольтамперфазометра
®
“ПАРМА ВАФ -А” с принадлежностями
3

РА1.007.001РЭ-007                              ООО «ПАРМА»
ВНИМАНИЕ!
Не приступайте к работе с прибором, не изучив содержание дан-
ного документа. В связи с постоянной работой по совершенствованию
прибора  в конструкцию  могут  быть  внесены  изменения,  не  влияющие
на его технические характеристики и не отраженные в настоящем доку-
менте.
4