Руководство по эксплуатации магнитолы хендай

Инструкция и руководство для
Hyundai H-1419 на русском на английском

17 страниц подробных инструкций и пользовательских руководств по эксплуатации

Cтерео магнитола с CD…

H-1419, Cтерео магнитола с cd/mp3/usb/sd, Инструкция по эксплуатации

• Изображение
• Текст

H-1419

Cтерео магнитола с CD/MP3/USB/SD

Инструкция по эксплуатации

CD/MP3/USB/SD radio player
Instruction manual

2

Description

Unit description

1. CD

door

2. IR

sensor

3. CD door finger grip
4. LCD

display

5. Handle
6. PLAY/ PAUSE key
7. BACK

/TUNE DOWN key

8. CD

key

3

Remote control description

1. VOLUME +/– keys
2. POWER

key

3. STOP

key

4. PLAY/PAUSE

key

5. BASS

key

6. EQ

key

7. SLEEP

key

4

Important safeguards

• ATTENTION: The owner’s manual contains important operating and maintenance instructions. For your safety, it is necessary to refer to the manual.
• DANGEROUS VOLTAGE: Uninsulated dangerous voltage that may be of sufficient magnitude to constitute a risk of electrical shock to persons is

present within this product enclosure.

• CAUTION: To reduce the risk of electric shock, do not remove cover (or back). Prefer servicing to qualified service personnel.

Power supply

Battery operation

• Open the battery compartment cover

• Insert 6 batteries (UM-2/LR14). Please observe correct battery polarities or the set will not work.

• Close the battery compartment cover.

AC operation

• Before the first connecting of the appliance check that voltage indicated on the rating label corresponds the mains voltage in your home.

• The AC cord is located inside the battery compartment. Connect it to the unit.
• Insert the plug into power supply.
CAUTION:

• When the set is only used with AC or is not used for 4 weeks or more, please remove the batteries, to avoid damage to the set from leakage of batteries.

• Always switch off the unit when not in use.
• Always unplug the appliance from power supply, when no use long time.

Radio operations

• Press ON/OFF key once to switch on the system power.

• Press BAND key repeatedly to select the radio mode and the desired radio band: AM or FM
• Press NEXT/TUNE-UP button or BACK/TUNE-UP button and then release the button when the fast scanning starts. The frequency will continue to

change and will automatically stop when a broadcast station is received.

• To receive a weak broadcast signal press the NEXT/TUNE-UP or BACK/TUNE-DOWN button by one press at a time and adjust the frequency you wish

to receive.

5

Saving stations to memory

• 50 broadcast stations: 30 FM band and 20 AM stations can be stored to the preset memory.
• During tuner mode, find a desired station.

• Press MEM/PROG/P-MODE

key to activate memory setting mode.

• Press -10/MEM – key or +10/MEM + key to choose the desired memory location. The location number is flashing on the left side of the screen.
• Press MEM/PROG/P-MODE

key again to store the desired station.

• Repeat steps for storing stations to other locations.

• To clear the memory of any location simply save a new station to the same memory.

Selecting stored stations

• Press -10/MEM – key or +10/MEM + key to choose the memory location. The stored station will be selected.

Antenna

• For FM reception, adjust the telescopic antenna appropriately to obtain the best reception on the band selected.

• The AM signals are picked up through the built-in ferrite antenna. The set should be placed to a position for the best reception.

FM and FM stereo reception

• In particular when stereo signal is weak and much noise are received, it is preferable to receive the program in mono. Press FOLDER/FM-MODE button

to switch between FM stereo and mono modes.

Compact disc operation

Insertion and removal of discs

• When opening the CD-door, always ensure the disc is not in motion (not spinning) when you open the CD-door. Always press «STOP» button to stop the

disc spinning first.

• Place a CD into the compartment with the label-side (printed side of disc) facing upwards. Press down in the center part of disc until the disc «locks» onto

the center spindle.

• When the CD has been placed onto the center spindle, gently lower the CD-door downwards until it locks shut.

• The CD is now ready to be played.
• To remove a disc, follow the same procedure as described above, except to remove the CD instead of inserting it into the compartment, by placing one

finger at the middle of disc (center spindle) & the other at the edge of the disc & gently pulling upwards.

Important :
Always hold a CD by its edges. Avoid getting any finger prints, smudges or dirt onto the surface of a disc. In case this happens, use a special CD-cleaning
cloth or cleaning kit to remove the dirt or smudges.
Important: Please make sure to always fold down the handle before opening the CD door.
• Press ON/OFF key once to switch on the system power.

6

• Press CD key to enter CD mode.
• Put a CD into the CD compartment and close the CD door.

• The display will indicate «READ» for a few seconds and then start to play the first track.

• The display will indicate the current track number and playback time.

Play/pause mode

• Press the PLAY/PAUSE button to pause at any track when playing. Press PLAY/PAUSE button again to resume playing.

• To stop the CD, press the STOP button. If you press PLAY/PAUSE button now the playback will start from first track.

Skip and search mode

• Press the NEXT/TUNE UP button once to skip to the next track. Press and hold this button to search for a particular point at high speed forward. Release

the button to resume normal play.

• Press the BACK/TUNE DOWN button once to the beginning of the current track. Press the BACK/TUNE DOWN button twice to skip back to previous

track. Press and hold this button to search for a particular point at high speed backward. Release the button resume normal play.

Repeat, intro and random modes

• Press the MEM/PROG/P-MODE key repeatedly to select the following options:

—

REPEAT – to repeat the current track

—

REPEAT ALL – to repeat all tracks (full CD, USB or SD)

—

INTRO – to «sample» all the music on the CD/USB/SD (about first 12 seconds of every song will be played)

—

RANDOM – to play a random mix of all the songs on CD/USB/SD

Program mode

• Up to 60 tracks can be programmed for disc play in any order or the same track can be repeated up to 60 times.
• Before use, be sure to stop the CD by pressing the STOP button.

• Press the MEM/PROG/P-MODE

key. The display will show «P01». This indicates that the set is now in memory programming mode, at the first memory

position.

• Select a desired track by using the BACK/TUNE DOWN and NEXT/TUNE UP buttons.
• Press the MEM/PROG/P-MODE

key again to confirm.

• The set will advance to next memory position, the display will show «P02».

• Repeat steps described above to enter additional memories into the program if necessary.
• After a maximum of 60 songs (or less) have been selected as described above, press the PLAY/ PAUSE button to start playing the programmed tracks.

• The «PROG» symbol will appear to indicate that you have saved a program-memory (sequence).

• The program memory will be cleared when you press STOP button twice.

7

MP3 operation

• Press ON/OFF key once to switch on the system power
• Press CD key to enter CD mode.

• Open the CD door. Put a MP3 disk into the CD compartment and close the CD door.

• The disk will spin and perform a full check of the disc to count the total number of songs. Then playback of the first song (track) will begin and the

display will indicate the current track no: (001). On the display «MP3» symbol will appear to indicate that MP3-CD is playing.

• Press the NEXT/TUNE UP button once to skip to the next track. Press and hold this button to search for a particular point at high speed forward. Release

the button to resume normal play.

• Press the BACK/TUNE DOWN button once to the beginning of the current track. Press the BACK/TUNE DOWN button twice to skip back to previous

track. Press and hold this button to search for a particular point at high speed backward. Release the button resume normal play.

• You can use the +10/MEM + key to jump 10 songs ahead or -10/ MEM — key to jump 10 songs backward. This is useful if you have many songs on you

want to quickly jump to a particular song.

• Press +10/MEM + key or -10/MEM — key several times until you reach a song number near to your desired song, and then press BACK/TUNE DOWN

or NEXT/TUNE UP repeatedly to arrive and the exact song you desire.

• If your MP3-CD has folders, you can select the folder to playback. Press FOLDER/FM-MODE (FM mono/stereo) key to switch to the next folder. The

set will start playing the first song in the next folder.

• If the set is in «STOP» mode and you press FOLDER/FM-MODE (FM mono/stereo) key, the unit will switch to the next folder but the playback will not

start automatically. Press PLAY/PAUSE button to start playback.

Note: Good quality sound is guaranteed only when playing licensed MP3 discs.

Text dispay mode (ID3-tag)

• The set can display the text information (ID3-tags) of MP3 files on the LCD.

• During playback of an MP3 file approximately every 5 seconds the display will automatically switch to text mode and display ID3-tag information.

• After the ID3-tag information has been displayed the unit will switch back to the normal display (track # and palyback time) for about another 5 seconds.
• This sequence will repeat continuously as follows: Track number + playback time display (about 5 seconds) => ID3-tags (text display).

USB flash drive/ SD-card operations

• This unit is equipped with a USB socket which can accept and play MP3 files stored on standard USB flash (compatible with usb version 1.1 & 2.0).
• This unit is also equipped with an SD card socket which can accept and play MP3 files stored on standard SD cards.

• To use USB drives/ SD cards for MP3 playback insert the USB drive or SD card into the appropriate socket and press the USB/ SD key (once for USB

and twice for SD card).

• The display will show “USB” or «SD» (depending on which one you are using) symbol.
• If MP3 files are found the set will start playback of the first file.

• Playback control is same as for MP3-CD discs.

8

Important: Always switch off the unit or change mode to “CD” or “RADIO” before removing a USB flash drive or SD card, to prevent damage to your
USB device or memory card.
Note: Although this product is fully compatible with USB 1.1 & 2.0 and SD card standard formats, a small percentage of USB flash drives and SD cards
might not be readable, due to those device manufacturers non-compliance with the full (official) USB and SD cards standards.

Electronic volume control

• This unit uses an electronic volume control
• To increase or decrease the loudness of unit, press the VOL.UP or VOL.DN keys respectively

• Volume loudness level is indicated in the LCD display in 30 steps (0 = minimum, 30 = maximum)

Music equalizer

• Press EQ key repeatedly to choose the desired sound effect according to the music you are listening to: FLAT (EQ off) => CLASSIC => ROCK => POP

=> JAZZ.

Automatic power off (sleep) function

• This set has a special sleep timer function which can automatically switch off the unit.
• At any time while the unit is operating (CD player or radio), press SLEEP key repeatedly to choose the automatic power off time: 90 min => 80 min =>

70 min => 60 min => 50 min => 40 min => 30 min => 20 min => 10 min => OFF.

Maintenance and care

• Check your batteries regularly, old or discharged batteries should be replaced. If the unit is not going to be used for some time or is

being run exclusively on the alternative power, remove the batteries to avoid leakage and damage.

• Electronic products of this kind should never be subjected to moisture or extreme temperatures.
• If necessary, clean the unit with a piece of cloth dampened with water only (be sure the AC power cord is disconnected from the

power supply).

• The heads and capstan are in constant contact with the moving tape. Use a small cotton bud with alcohol or special tape head cleaner

to clean these parts. Never touch the heads with anything metallic.

CD protection

• When pick up the CD disc, always hold the edge of the disc, never touch the surface of the disc, it would scratch the disc surface and

may occur sound distortion or raise reading problem.

9

Specification

CD playback format

MP3

CD types

CD/CD-R/CD-RW

Power supply

220 V, 50 Hz

Output power, RMS

3 W x 2

FM range

88-108 MHz

AM range

530 kHz — 1600 kHz

Net / Gross weight

Gift box dimension (L x W x H)

Specifications and functions are subject to change without notice. It is caused by continual improvement of the device.

10

Описание

Описание магнитолы

Комментарии