Tainet t 336cx инструкция на русском

• Contents

• Table of Contents

• Troubleshooting

• Bookmarks

Summary of Contents for Tainet T-336Cx

• CHAPTER 5 : INSTRUCTION SETS Cmd Function Description AT&Yn powerup user profile n (n=0~9) 0 : load user profile 0 on power up n : load user profile n on power up AT&Zn view/store telephone number n (n=0~9) n = 0 .. 9, the selected telephone number AT&Zn? : view tel number n AT&Zn=string : store the string to tel number n. ATJn DTE/DCE speed convert on/off 0 : enable DTE/DCE speed convert 1 : disable DTE/DCE speed convert ATNn

• CHAPTER 5 : INSTRUCTION SETS 5.3 Result Codes Table 5-3 AT Command Result Codes Short Long form 0 OK 1 CONNECT 2 RING 3 NO CARRIER 4 ERROR 5 CONNECT 1200 6 NO DIAL TONE 7 BUSY 8 NO ANSWER TONE 9 None 10 CONNECT 300 11 CONNECT 600 12 None 13 CONNECT 1800 14 CONNECT 2400 15 CONNECT 3600 16 CONNECT 4800 17 CONNECT 7200 18 CONNECT 9600 19 CONNECT 12000 20 CONNECT 14400 21 CONNECT 16800 22 CONNECT 19200 23 CONNECT 21600 54
  

• CHAPTER 1： TAINET MODEM INTRODUCTION Chapter 1 TAINET MODEM INTRODUCTION 1.1 Description 1.2 Technical Specifications 1.3 Ordering Information 1
  

• CHAPTER 3 : FRONT PANEL AND MENU TREE 3.5 Detailed Description of the Menu Tree 3.5.1 STATUS MENU Item Name Command Description TX LEVEL = -XX dBm AT%S Transmitted signal level. This value is equal to the » TX level» of config modem. Normally, for the 2w leased line and the dial line, the recommended value is between -10 and -13dBm. It can be increased of in order to obtain a more satisfactory S/N

• APPENDIX 3:T-336Nx LCD MENU QUICK REFERENCE APPENDIX 3:T-336Nx LCD MENU QUICK REFERENCE ↓ = «ENTER” KEY ↑ = «EXIT” KEY → =“>” KEY ← =“<” KEY Card Selection = «CARD#” KEY Go to the top layer of menu tree = «HOME” KEY NMC — 16 V5.xx-11 ID=001 01Select Menu Modem Control 01 Secect Menu 3333333333333333 V34 Adapt Direct D ANS Standby 01Select Menu Current Alarm 01 Current Alarm No alarm or alarm occur RXL Low RXL High SNR Bad DTR Off N-

• CHAPTER 5 : INSTRUCTION SETS Table 5-3 Result Codes (cont.) Short Long form 24 CONNECT 24000 25 CONNECT 26400 26 CONNECT 28800 27 CONNECT 32000 28 CONNECT 38400 29 CONNECT 57600 30 CONNECT 76800 31 CONNECT 115200 32 CONNECT 31200 33 CONNECT 33600 55
  

• CHAPTER 2: INSTALLATION 2) If you are unsure whether the electrical service in your building is properly grounded, have it examined by your municipal electrical inspector. 3) Install a surge protector between the modem and AC power outlet. Any additional computer equipment you have connected to the modem (directly or through another device), such as a terminal or printer, should also be plugged into the same surge protector. Make sure that th

• APPENDIX 1: T-336Cx S-REGISTER TABLE APPENDIX 1: T-336Cx S-REGISTER TABLE No Default Unit Function Description S0 1 times Auto-answer Ring Count S1 0 times Current Ring Count (read only) S2 43 decimal Escape Char S3 13 decimal CR Char S4 10 decimal LF Char S5 8 decimal Backspace Char S6 2 second Pause Before Blind Dial S7 45 second Wait for Carrier Time S8 2 second Pause for Comma S9 6 100ms Carrier Validation Time S10 15 1/.1s Lost Carrier Detect Time ( 1 sec unit for V34/V32bis/V32)

• CHAPTER 3 : FRONT PANEL AND MENU TREE 3.5.2 DIAL MENU Item Name Command Description Dial a Number #0…#9 ATDSn Dial out a preset telephone number #n(n=0..9). This function can interact with the auto redial function or dial line auto establishment function. Edit a Number #0…#9 AT&Zn = xx Edit telephone number #n (n=0..9) for up to 20 digits each group.If the «@» is included inside th

• CHAPTER 3 : FRONT PANEL AND MENU TREE CHAPTER 3 : FRONT PANEL AND MENU TREE 3.1 The Front Panel Description There are 5 key on the front panel of TAINET’s Modem (VO/DA Key, Right Key, Left Key, ENTER Key and EXIT Key), one 2 x 16 LCD displayer and 10 LEDs. Through these interfaces, users are able to see the status of modem or chang the configurations as illustrated below: Figure 3-1 TAINET T-336Cx Front Panel 3.2 The Rear Panel Description The rear panel of TAINET T

• CHAPTER 4: GENERAL INFORMATION AND FEATURES 4.3 2W/4W Leased Line We had talked modem operate in the previous section. There are two-wire leased lined and four-wire leased line. 2W leased line achieves full duplex with only a pair of lines. There comes up the problem of interference. In V.21, V.22, V.22bis operating modes, the T-336Cx used the frequency split method. Whereas, in V.32/V32bis/V.34 mode, it must

• CHAPTER 1： TAINET MODEM INTRODUCTION 1.2 Technical Specifications T-336Cx/Nx/NDx fully comply with ITU-T recommendations V.34, V.32bis, V.32, V.22bis, V.22, V.21, V.23, V.24, V.26bis,V.28, V.25, V.25bis, V.52, V.54, V.42, V.42bis, V.8, and BELL 212A/103 operating standards. • Modulation type : Refer to table 1-1A,1-1B. • Clock tolerance (1) Synchronous : ± 0.01% (2) Asynchronous : Basic range + 1% to — 2.5% Extended overspeed range + 2.3% to — 2.5% • DTE speed (1

• CHAPTER 2: INSTALLATION CHAPTER 2: INSTALLATION 2.1 Description This chapter provides the information needed to install the TAINET Network Series Modem and to ensure that it is working properly. You may obtain more information about this subject for rack-mount modem shelf from the User’s Manual of TAINET TRS16 or TRS32 rack-mount modem shelf. 2.2 Unpacking Save the carton and protective packing material in which your TAINET Network Series Modem was shipped; you might need them for repackaging if you have to store or ship the modem in the future. T

• CHAPTER 3 : FRONT PANEL AND MENU TREE password. Time required for sending password is about 2 seconds; Control code ‘+’ can be applied in #0..#9. CallBack No. (Call back telephone number). Assign one of the stored phone number #0..#9 as the Call Back Number. Control codes such as ‘+’, ‘<’, ‘>’ should not appear in phone number. #0..#9 CallBack Timer The period ANS modem will